Enchanter Companion Pet behavior

[Nezoic]

When using an enchanter companion pet (caster) it will typically cast correctly on the first target. After that target dies and you command it to attack another target it will enter melee mode instead of immediately casting again. There is about a 3-5 second delay between when you can passive to attack and it will cast again. Video below.

https://www.youtube.com/watch?v=00Z7FNgfO00

[skrag]

I cannot pinpoint the exact steps to reproduce it, but this happens regularily to me as well, both with companion and zealot. Means you attack a mob normally with pet perfectly normal, then the next one it goes melee despite being not even close to melee range. Caused some fancy and totally unwanted pet pulls already.

[Sateist]

I can confirm the same. For some reason the companion will opt to go melee. Some toggles between passive and attack command seem to "fix" it.

[Karen]

This has been resolved in S2 Patch #43, please open a new ticket if any other issue persists. Thank you for your reports.